sheemer@沖縄です。2.5CRのインストール後、PCカードを抜き差しすると 凍ってしまいます。それについてお教え下さい。 マシンはIBM iSeries s30です。ビルトインのイーサネットの方。 http://www-6.ibm.com/jp/pc/thinkpad/tpis3015/tpis3015a.html http://www.ryukyu.ne.jp/~sheemer/notesandcomments/20010929.html http://www.ryukyu.ne.jp/~sheemer/notesandcomments/20020105.html Vine2.1.5まではこのマシンで快適に使っておりました。今回、Vine2.5ftpおよび Vine2.5CRどちらもクリーンインストールしてみましたが、PCカードを抜くと いきなり凍ります。抜いたとたんに画面の時計の秒表示が固まり、マウスや トラックポイントも動作を受けつけなくなります。仮想コンソールへも 移れず、他マシンからのリモートログインもできず、電源スイッチで落すしか ありません。 /var/log/messagesにも何も残っていません: May 15 16:34:05 quinne kernel: PCI: Found IRQ 5 for device 00:00.2 May 15 16:34:05 quinne kernel: PCI: Sharing IRQ 5 with 00:00.1 May 15 16:34:05 quinne cardmgr[589]: executing: './serial start ttyS0' May 15 16:34:05 quinne kernel: ttyS00 at port 0x03f8 (irq = 3) is a 16550A ---(ここまでp-in M@sterを抜き差ししている。ここでPCカードを抜くといきなり凍る) May 15 16:41:39 quinne syslogd 1.4-0: restart. May 15 16:41:39 quinne syslog: syslogd startup succeeded May 15 16:41:39 quinne kernel: klogd 1.4-0, log source = /proc/kmsg started. May 15 16:41:39 quinne kernel: Inspecting /boot/System.map-2.4.18-0vl3 これまで確認したのはUSRoboticsのXjack型の古いイーサカード(インストールには これを使いました)と、ハギラワシスコムのスマートメディアカードです。どちらも 2.1.5までは健全に使えていましたが、今回は挿すといきなり凍ります。 下側の別のCFスロットのp-in M@sterは抜き差ししても凍りません。 挙動からはハードウェアと関連している気もしますが、Vine2.1.5までは問題なく 使えていましたので、どうもよくわかりません。 どう調べて行ったらよいでしょうか。 ●BIOS画面におけるIRQ 1st PCI IRQ 11 2nd PCI IRQ 5 3rd PCI IRQ 11 4th PCI IRQ 10 ●# cat /proc/interrupts CPU0 0: 449262 XT-PIC timer 1: 5983 XT-PIC keyboard 2: 0 XT-PIC cascade 5: 0 XT-PIC Texas Instruments PCI1420 8: 1 XT-PIC rtc 10: 63040 XT-PIC usb-uhci, eth0 11: 28 XT-PIC Texas Instruments PCI1420 (#2) 12: 56 XT-PIC PS/2 Mouse 14: 89281 XT-PIC ide0 NMI: 0 ERR: 0 ●dmesg Linux version 2.4.18-0vl3 (sagami@xxxxxxxxxxxxxxxxxxx) (gcc version 2.95.3 20010315 (release)) #1 Thu Mar 7 18:23:04 JST 2002 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 000000000009f400 (usable) BIOS-e820: 000000000009f400 - 00000000000a0000 (reserved) BIOS-e820: 00000000000dc000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 0000000007ff0000 (usable) BIOS-e820: 0000000007ff0000 - 0000000007ff3c00 (ACPI data) BIOS-e820: 0000000007ff3c00 - 0000000008000000 (ACPI NVS) BIOS-e820: 00000000fff80000 - 0000000100000000 (reserved) On node 0 totalpages: 32752 zone(0): 4096 pages. zone(1): 28656 pages. zone(2): 0 pages. Kernel command line: auto BOOT_IMAGE=linux ro root=305 BOOT_FILE=/boot/vmlinuz-2.4.18-0vl3 Initializing CPU#0 Detected 597.410 MHz processor. Console: colour VGA+ 80x25 Calibrating delay loop... 1192.75 BogoMIPS Memory: 126244k/131008k available (1360k kernel code, 4376k reserved, 451k data, 216k init, 0k highmem) Dentry-cache hash table entries: 16384 (order: 5, 131072 bytes) Inode-cache hash table entries: 8192 (order: 4, 65536 bytes) Mount-cache hash table entries: 2048 (order: 2, 16384 bytes) Buffer-cache hash table entries: 4096 (order: 2, 16384 bytes) Page-cache hash table entries: 32768 (order: 5, 131072 bytes) CPU: Before vendor init, caps: 0383f9ff 00000000 00000000, vendor = 0 CPU: L1 I cache: 16K, L1 D cache: 16K CPU: L2 cache: 256K CPU: After vendor init, caps: 0383f9ff 00000000 00000000 00000000 Intel machine check architecture supported. Intel machine check reporting enabled on CPU#0. CPU: After generic, caps: 0383f9ff 00000000 00000000 00000000 CPU: Common caps: 0383f9ff 00000000 00000000 00000000 CPU: Intel Pentium III (Coppermine) stepping 0a Enabling fast FPU save and restore... done. Enabling unmasked SIMD FPU exception support... done. Checking 'hlt' instruction... OK. POSIX conformance testing by UNIFIX mtrr: v1.40 (20010327) Richard Gooch (rgooch@xxxxxxxxxxxxx) mtrr: detected mtrr type: Intel PCI: PCI BIOS revision 2.10 entry at 0xfd9cf, last bus=0 PCI: Using configuration type 1 PCI: Probing PCI hardware (bus 00) PCI: Using IRQ router PIIX [8086/7198] at 00:07.0 PCI: Found IRQ 11 for device 00:0a.1 PCI: Sharing IRQ 11 with 00:09.0 IRQ routing conflict for 00:0a.0, have irq 5, want irq 11 Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket IBM machine detected. Enabling interrupts during APM calls. apm: BIOS version 1.2 Flags 0x03 (Driver version 1.16) Starting kswapd VFS: Diskquotas version dquot_6.4.0 initialized Journalled Block Device driver loaded pty: 256 Unix98 ptys configured Non-volatile memory driver v1.1 block: 128 slots per queue, batch=32 RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize Uniform Multi-Platform E-IDE driver Revision: 6.31 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx PIIX4: IDE controller on PCI bus 00 dev 39 PIIX4: chipset revision 0 PIIX4: not 100% native mode: will probe irqs later ide0: BM-DMA at 0x1c20-0x1c27, BIOS settings: hda:DMA, hdb:pio hda: IBM-DJSA-220, ATA DISK drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 blk: queue c0330bc0, I/O limit 4095Mb (mask 0xffffffff) hda: 39070080 sectors (20004 MB) w/1874KiB Cache, CHS=2432/255/63, UDMA(33) ide-floppy driver 0.97.sv Partition check: hda: hda1 hda2 hda3 < hda5 hda6 hda7 > floppy0: no floppy controllers found loop: loaded (max 8 devices) bond0 registered without MII link monitoring, in bonding mode. Equalizer1996: $Revision: 1.2.1 $ $Date: 1996/09/22 13:52:00 $ Simon Janes (simon@xxxxxxx) Universal TUN/TAP device driver 1.4 (C)1999-2001 Maxim Krasnyansky ide-floppy driver 0.97.sv usb.c: registered new driver usbdevfs usb.c: registered new driver hub mice: PS/2 mouse device common for all mice NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP, IGMP IP: routing cache hash table of 512 buckets, 4Kbytes TCP: Hash tables configured (established 8192 bind 8192) Linux IP multicast router 0.06 plus PIM-SM NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. VFS: Mounted root (ext2 filesystem) readonly. Freeing unused kernel memory: 216k freed Real Time Clock Driver v1.10e Adding Swap: 136512k swap-space (priority -1) md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27 usb.c: registered new driver hiddev usb.c: registered new driver hid hid-core.c: v1.8 Andreas Gal, Vojtech Pavlik <vojtech@xxxxxxx> hid-core.c: USB HID support drivers uhci.c: USB Universal Host Controller Interface driver v1.1 PCI: Found IRQ 10 for device 00:07.2 PCI: Sharing IRQ 10 with 00:0c.0 uhci.c: USB UHCI at I/O 0x1c00, IRQ 10 usb.c: new USB bus registered, assigned bus number 1 hub.c: USB hub found hub.c: 2 ports detected hub.c: USB new device connect on bus1/2, assigned device number 2 input0: USB HID v1.00 Mouse [ELECOM ELECOM USB mouse with wheel] on usb1:2.0 usb.c: registered new driver usb_mouse usbmouse.c: v1.6:USB HID Boot Protocol mouse driver isapnp: Scanning for PnP cards... isapnp: No Plug & Play device found Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI ISAPNP enabled PCI: Found IRQ 5 for device 00:00.2 PCI: Sharing IRQ 5 with 00:00.1 ip_conntrack (1023 buckets, 8184 max) eepro100.c:v1.09j-t 9/29/99 Donald Becker http://www.scyld.com/network/eepro100.html eepro100.c: $Revision: 1.36 $ 2000/11/17 Modified by Andrey V. Savochkin <saw@xxxxxxxxxxxxx> and others PCI: Found IRQ 10 for device 00:0c.0 PCI: Sharing IRQ 10 with 00:07.2 eth0: OEM i82557/i82558 10/100 Ethernet, 00:90:96:16:FC:60, IRQ 10. Board assembly 506470-151, Physical connectors present: RJ45 Primary interface chip i82555 PHY #1. General self-test: passed. Serial sub-system self-test: passed. Internal registers self-test: passed. ROM checksum self-test: passed (0x04f4518b). Linux Kernel Card Services 3.1.22 options: [pci] [cardbus] [pm] PCI: Found IRQ 11 for device 00:0a.0 PCI: Sharing IRQ 11 with 00:09.0 IRQ routing conflict for 00:0a.0, have irq 5, want irq 11 PCI: Sharing IRQ 11 with 00:0a.1 PCI: Found IRQ 11 for device 00:0a.1 PCI: Sharing IRQ 11 with 00:09.0 IRQ routing conflict for 00:0a.0, have irq 5, want irq 11 Yenta IRQ list 02d8, PCI irq5 Socket status: 30000006 Yenta IRQ list 02d8, PCI irq11 Socket status: 30000010 cs: IO port probe 0x0c00-0x0cff: clean. cs: IO port probe 0x0100-0x04ff: excluding 0x4d0-0x4d7 cs: IO port probe 0x0a00-0x0aff: clean. cs: memory probe 0xa0000000-0xa0ffffff: clean. ttyS00 at port 0x03f8 (irq = 3) is a 16550A eth0: 0 multicast blocks dropped. tty00 unloaded isapnp: Scanning for PnP cards... isapnp: No Plug & Play device found Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI ISAPNP enabled PCI: Found IRQ 5 for device 00:00.2 PCI: Sharing IRQ 5 with 00:00.1 ttyS00 at port 0x03f8 (irq = 3) is a 16550A -- KYUSHIMA Masahiro, MD Division of Cardiology, Chief, Division of Medical Informatics, Okinawa Chubu Hospital, Okinawa, Japan. +81-98-875-6743(fax) http://www.ryukyu.ne.jp/~sheemer/