田中宏明です。
Vine 4.1 に切替えて、しばらくぶりに epson GT-8200U スキャナ を
利用しようと思ったのですが、うまくいきません。
# いままでは シノバー さんの Web に御世話になっていたのですが。
# 最終的には GIMP から利用したいと考えています。
sane はインストール済みで、
# sane-find-scanner
found USB scanner (vendor=0x04b8 [EPSON], product=0x0110 [EPSON Scanner])
at libusb:001:004
までは確認済なのですが、
# scanimage -L
No scanners were identified. If you were expecting something different,
check that the scanner is plugged in, turned on and detected by the
sane-find-scanner tool (if appropriate). Please read the documentation
which came with this software (README, FAQ, manpages).
と来ますので、おそらく /etc/sane.d/epson.conf の
デバイスファイルの設定だろうと思うのですが、
udev に変わったことでデバイスファイルも動的に作成されるようで……。
$ dmesg | grep usb
usbcore: registered new driver usbfs
usbcore: registered new driver hub
usbmon: debugfs is not available
usbcore: registered new driver libusual
usbcore: registered new driver hiddev
usbcore: registered new driver usbhid
drivers/usb/input/hid-core.c: v2.6:USB HID core driver
usb usb1: configuration #1 chosen from 1 choice
usb usb2: configuration #1 chosen from 1 choice
usb 1-2: new full speed USB device using uhci_hcd and address 2
usb 1-2: configuration #1 chosen from 1 choice
usb 1-2: USB disconnect, address 2
usb 1-2: new full speed USB device using uhci_hcd and address 3
usb 1-2: configuration #1 chosen from 1 choice
usb 1-2: USB disconnect, address 3
usb 1-2: new full speed USB device using uhci_hcd and address 4
usb 1-2: configuration #1 chosen from 1 choice
こういう場合に /etc/sane.d/epson.conf には
どういう風に指定するのでしょう?
動作している方、ご教示ください。
--
zzzz zzzz zzzz zzzz zzzz zzzz zzzz zzzz zzzz zzzz zzzz zzzz zzzz zzzz
[ [ [ 田中宏明 mosaicist@xxxxxxxxxxxxx
[ [ [ From the bottom line on the Vine
zzzz zzzz zzzz zzzz zzzz zzzz zzzz zzzz zzzz zzzz zzzz zzzz zzzz zzzz