亀井です。
From: TANAKA hiroaki <mosaicist@xxxxxxxxxxxxx>
Subject: [vine-users:052602] Re: gimp with xscanimage
Date: Wed, 7 Aug 2002 00:09:52 +0900
> > vine2.5でsane-1.0.3とsane-cliantをinstallし
> > xscanimage単体では動作確認がとれたのですが、gimpからの起動ができません。
>
> VineSeed/VineSeedPlus/RPMS/i386/
> に
> sane-1.0.7-0vl2.i386.rpm 2219 KB
> sane-clients-1.0.7-0vl1.i386.rpm 92 KB
> sane-devel-1.0.7-0vl2.i386.rpm
>
> があります。
> こちらだとどうでしょうか?
まずは
VineSeed/VineSeedPlus/RPMS/i386/から
sane-1.0.7-0vl2.i386.rpm 2219 KB
sane-clients-1.0.7-0vl1.i386.rpm 92 KB
をinstallしてみました。
gimpを立ち上げて確かに
「拡張」->「Acquire Image」があらわれるようにはなったのですが、、、。
xscanimageが立ち上がらなくなりました。
(ide-scsiを使っているのでaic7xxxがロードされない?)マシンを起動後手動で
# insmod aic7xxx
として
# find-scanner
find-scanner: found SCSI scanner "CANON IX-06015C 1.04" at device /dev/scanner
find-scanner: found SCSI scanner "CANON IX-06015C 1.04" at device /dev/sg1
find-scanner: found SCSI scanner "CANON IX-06015C 1.04" at device /dev/sgb
となるのですが、
# scanimage -L
No scanners were identified. If you were expecting something different,
check that the scanner is plugged in, turned on and detected by the
sane-find-scanner tool (if appropriate). Please read the documentation
which came with this software (README, FAQ, manpages).
となってしまいます。
/etc/sane.d/canon.confは1.0.7の
#canon.conf
/dev/scanner
#/dev/sg0
も、1.0.3の時に自分で設定した
scsi CANON
/dev/scanner
でも、同じでした。
なんか、後一息と言った感じなのですが、、、。
みなさんの御意見お待ちしております。
---
亀井 孝幸
kamei@xxxxxxxxxxxxx
www.reallife.jp