MLの皆様お世話になっております iSP 岩崎＠川崎市です。 HCF 56k Data/Fax Modem その後の状況です。 >setserial -a /dev/modem >setserial -a /dev/ttySHCF0 > では >--------------------------------------------------------------------------- >/dev/modem, Line 0, UART: undefined, Port: 0x0001, IRQ: 0 > Baud_base: 115200, close_delay: 50, divisor: 0 > closing_wait: 3000 > Flags: spd_normal >-------------------------------------------------------------------------- CONEXANT Linux drivers for Conexant Chips - HCF FAQ から、 -------------------------------------------------------------------------- 6) Changing serial port parameters with "setserial" on ttySHxF0 or /dev/modem doesn't work. Since this modem driver provides a virtual serial interface, which is not directly connected to a physical UART like a normal serial port, it is not possible and would not make sense to configure it with "setserial". Therefore you shouldn't use this command on the ports associated with this driver /dev/ttySHCF0は->/dev/modemは、仮想シリアルポートで setserialで得られた情報は意味が無いようです。 また問題は、これのようで -------------------------------------------------------------------------- 7) I installed the driver, and now the /dev/ttySHxF0 or /dev/modem device is supposed to be there but it doesn't exist. On devfs-based systems (such as Mandrake), the missing device node is often a sign that the driver modules didn't load or initialize properly. Try "modprobe hcfpciserial" (or hcfusbserial), then check the /var/log/messages file or or run "dmesg" to see any kernel error messages that could provide a clue as to why loading of the driver failed. -------------------------------------------------------------------------- #dmesg では ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++ HCF ASIC ID: 215 2197218.147: HCF: DEVMGR ERROR: DpReset: timed out waiting for checksum 1 2197218.147: HCF: DEVMGR ERROR!!!! DpReset returns FALSE, attempt=0 HCF DATAPUMP PART: '71' REV: 'BA' 2197218.828: HCF: !!!ERROR: wrong ring params??? ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++ と、 HCF: !!!ERROR: wrong ring params??? を解決すれば、良いようなのですが、 どなたか、情報をお持ちの方はおられませんか？ （他力本願・・汗） 以上 ------------------------------------------ iSP 岩崎＠川崎市