小林です。 政さんの指示に従いまして変更しましたが、状況に変化はありませんでした。 なおdmesgですが、以下の通りでした。 Linux version 2.4.27-0vl7 (daisuke@xxxxxxxxxxxxxxxxxxxxx) (gcc バージョ ン 3.3.2 20031218 (Vine Linux 3.3.2-0vl8)) #1 2004年 10月 27日 水曜日 13:30:16 JST BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 000000000009f800 (usable) BIOS-e820: 000000000009f800 - 00000000000a0000 (reserved) BIOS-e820: 00000000000e8c00 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 000000001fff0000 (usable) BIOS-e820: 000000001fff0000 - 000000001ffffc00 (ACPI data) BIOS-e820: 000000001ffffc00 - 0000000020000000 (ACPI NVS) BIOS-e820: 00000000fff80000 - 0000000100000000 (reserved) 0MB HIGHMEM available. 511MB LOWMEM available. On node 0 totalpages: 131056 zone(0): 4096 pages. zone(1): 126960 pages. zone(2): 0 pages. Kernel command line: BOOT_IMAGE=linux ro root=303 acpi=off apm=on noapic resume2=swap:/dev/hda5 Local APIC disabled by BIOS -- reenabling. Could not enable APIC! Initializing CPU#0 Detected 597.452 MHz processor. Console: colour VGA+ 80x25 Calibrating delay loop... 1192.75 BogoMIPS Memory: 514204k/524224k available (2063k kernel code, 9632k reserved, 733k data, 160k init, 0k highmem) Dentry cache hash table entries: 65536 (order: 7, 524288 bytes) Inode cache hash table entries: 32768 (order: 6, 262144 bytes) Mount cache hash table entries: 512 (order: 0, 4096 bytes) Buffer cache hash table entries: 32768 (order: 5, 131072 bytes) Page-cache hash table entries: 131072 (order: 7, 524288 bytes) CPU: L1 I cache: 16K, L1 D cache: 16K CPU: L2 cache: 128K CPU: After generic, caps: 0383f9ff 00000000 00000000 00000000 CPU: Common caps: 0383f9ff 00000000 00000000 00000000 CPU: Intel Celeron (Coppermine) stepping 06 Enabling fast FPU save and restore... done. Enabling unmasked SIMD FPU exception support... done. Checking 'hlt' instruction... OK. POSIX conformance testing by UNIFIX mtrr: v1.41 (20040107) Richard Gooch (rgooch@xxxxxxxxxxxxx) mtrr: detected mtrr type: Intel ACPI: Subsystem revision 20040326 ACPI: Interpreter disabled. PCI: PCI BIOS revision 2.10 entry at 0xfd9ce, last bus=1 PCI: Using configuration type 1 PCI: Probing PCI hardware PCI: Probing PCI hardware (bus 00) PCI: Using IRQ router PIIX/ICH [8086/7110] at 00:07.0 PCI: Found IRQ 11 for device 00:07.2 Limiting direct PCI/PCI transfers. Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket apm: BIOS version 1.2 Flags 0x03 (Driver version 1.16) powernow: AMD processor not detected. cpufreq: Intel(R) SpeedStep(TM) for this chipset not (yet) available. gx-suspmod: error: no MediaGX/Geode processor found! Software Suspend LZF Compression Driver v1.0 Software Suspend Swap Writer v1.0 Starting kswapd VFS: Disk quotas vdquot_6.5.1 Journalled Block Device driver loaded pty: 256 Unix98 ptys configured Serial driver version 5.1 (2004-01-29) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled ttyS00 at 0x03f8 (irq = 4) is a 16550A PCI: Enabling device 00:0b.1 (0000 -> 0003) PCI: Assigned IRQ 10 for device 00:0b.1 PCI: Sharing IRQ 10 with 00:0b.0 Redundant entry in serial pci_table. Please send the output of lspci -vv, this message (115d,00d3,8086,2411) and the manufacturer and name of serial board or modem board to serial-pci-info@xxxxxxxxxxxxxxxxxxxxxx register_serial(): autoconfig failed Floppy drive(s): fd0 is 1.44M FDC 0 is a National Semiconductor PC87306 RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize loop: loaded (max 8 devices) Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx PIIX4: IDE controller at PCI slot 00:07.1 PIIX4: chipset revision 1 PIIX4: not 100% native mode: will probe irqs later ide0: BM-DMA at 0x1000-0x1007, BIOS settings: hda:DMA, hdb:pio ide1: BM-DMA at 0x1008-0x100f, BIOS settings: hdc:DMA, hdd:pio hda: HTS548040M9AT00, ATA DISK drive blk: queue c0421a00, I/O limit 4095Mb (mask 0xffffffff) hdc: MATSHITA CR-271, ATAPI CD/DVD-ROM drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 ide1 at 0x170-0x177,0x376 on irq 15 hda: attached ide-disk driver. hda: host protected area => 1 hda: 78140160 sectors (40008 MB) w/7877KiB Cache, CHS=4864/255/63, UDMA(33) hdc: attached ide-cdrom driver. hdc: ATAPI 24X CD-ROM drive, 128kB Cache, DMA Uniform CD-ROM driver Revision: 3.12 Partition check: hda: hda1 hda2 hda3 hda4 < hda5 hda6 > usb.c: registered new driver usbdevfs usb.c: registered new driver hub mice: PS/2 mouse device common for all mice md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27 md: Autodetecting RAID arrays. md: autorun ... md: ... autorun DONE. Initializing Cryptographic API NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP, IGMP IP: routing cache hash table of 4096 buckets, 32Kbytes TCP: Hash tables configured (established 32768 bind 65536) Linux IP multicast router 0.06 plus PIM-SM NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. Software Suspend 2.0.0.100: Attempting to set blocksize for 305 to 4096. Software Suspend 2.0.0.100: Swap space signature found. Software Suspend 2.0.0.100: Suspending enabled. Software Suspend 2.0.0.100: Checking for image... Software Suspend 2.0.0.100: This is normal swap space. RAMDISK: Compressed image found at block 0 Freeing initrd memory: 111k freed VFS: Mounted root (ext2 filesystem). kjournald starting. Commit interval 5 seconds EXT3-fs: mounted filesystem with ordered data mode. VFS: Mounted root (ext3 filesystem) readonly. Trying to move old root to /initrd ... okay Freeing unused kernel memory: 160k freed Real Time Clock Driver v1.10f Adding Swap: 522072k swap-space (priority -1) EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,3), internal journal PCI: Enabling device 00:0c.0 (0000 -> 0003) PCI: Assigned IRQ 5 for device 00:0c.0 ymfpci: YMF744 at 0xfe028000 IRQ 5 ac97_codec: AC97 Audio codec, id: AKM2 (Asahi Kasei AK4543) kjournald starting. Commit interval 5 seconds EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,2), internal journal EXT3-fs: mounted filesystem with ordered data mode.