池谷と申します。
小林さんとまったく同じ症状か分かりませんが、うちのPCでも同様な事が起きております。
当方ではftpインストールしたのですが、
カーネルオプション（acpi=off apm=on）を指定しなくても
shutdown -h now や poweroff で自動的に電源が切れました。
一方、shutdown -r now や reboot でサーバを再起動をした場合ですが、
各種デーモンのプロセスは正常終了して、rebootのメッセージが表示されるのですが、
その後、マシンの再起動が行われず、フリーズします。（フリーズと言うかは疑問ですが・・・）
現状、メッセージが出た後にPCのリセットボタンを押してます(^^;...
----- Original Message -----
From: "Hiroki Kobayshi" CBC03089@xxxxxxxxx
To: "vine-users ML" <vine-users@xxxxxxxxxxx>
Sent: Monday, January 03, 2005 8:50 PM
Subject: [vine-users:069477] Re: はじめまして
小林です。
政さんの指示に従いまして変更しましたが、状況に変化はありませんでした。
なおdmesgですが、以下の通りでした。
Linux version 2.4.27-0vl7 (daisuke@xxxxxxxxxxxxxxxxxxxxx) (gcc バージョ
ン 3.3.2 20031218 (Vine Linux 3.3.2-0vl8)) #1 2004年 10月 27日 水曜日
13:30:16 JST
BIOS-provided physical RAM map:
BIOS-e820: 0000000000000000 - 000000000009f800 (usable)
BIOS-e820: 000000000009f800 - 00000000000a0000 (reserved)
BIOS-e820: 00000000000e8c00 - 0000000000100000 (reserved)
BIOS-e820: 0000000000100000 - 000000001fff0000 (usable)
BIOS-e820: 000000001fff0000 - 000000001ffffc00 (ACPI data)
BIOS-e820: 000000001ffffc00 - 0000000020000000 (ACPI NVS)
BIOS-e820: 00000000fff80000 - 0000000100000000 (reserved)
0MB HIGHMEM available.
511MB LOWMEM available.
On node 0 totalpages: 131056
zone(0): 4096 pages.
zone(1): 126960 pages.
zone(2): 0 pages.
Kernel command line: BOOT_IMAGE=linux ro root=303 acpi=off apm=on noapic
resume2=swap:/dev/hda5
Local APIC disabled by BIOS -- reenabling.
Could not enable APIC!
Initializing CPU#0
Detected 597.452 MHz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 1192.75 BogoMIPS
Memory: 514204k/524224k available (2063k kernel code, 9632k reserved,
733k data, 160k init, 0k highmem)
Dentry cache hash table entries: 65536 (order: 7, 524288 bytes)
Inode cache hash table entries: 32768 (order: 6, 262144 bytes)
Mount cache hash table entries: 512 (order: 0, 4096 bytes)
Buffer cache hash table entries: 32768 (order: 5, 131072 bytes)
Page-cache hash table entries: 131072 (order: 7, 524288 bytes)
CPU: L1 I cache: 16K, L1 D cache: 16K
CPU: L2 cache: 128K
CPU: After generic, caps: 0383f9ff 00000000 00000000 00000000
CPU: Common caps: 0383f9ff 00000000 00000000 00000000
CPU: Intel Celeron (Coppermine) stepping 06
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.41 (20040107) Richard Gooch (rgooch@xxxxxxxxxxxxx)
mtrr: detected mtrr type: Intel
ACPI: Subsystem revision 20040326
ACPI: Interpreter disabled.
PCI: PCI BIOS revision 2.10 entry at 0xfd9ce, last bus=1
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: Probing PCI hardware (bus 00)
PCI: Using IRQ router PIIX/ICH [8086/7110] at 00:07.0
PCI: Found IRQ 11 for device 00:07.2
Limiting direct PCI/PCI transfers.
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
apm: BIOS version 1.2 Flags 0x03 (Driver version 1.16)
powernow: AMD processor not detected.
cpufreq: Intel(R) SpeedStep(TM) for this chipset not (yet) available.
gx-suspmod: error: no MediaGX/Geode processor found!
Software Suspend LZF Compression Driver v1.0
Software Suspend Swap Writer v1.0
Starting kswapd
VFS: Disk quotas vdquot_6.5.1
Journalled Block Device driver loaded
pty: 256 Unix98 ptys configured
Serial driver version 5.1 (2004-01-29) with MANY_PORTS SHARE_IRQ
SERIAL_PCI enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
PCI: Enabling device 00:0b.1 (0000 -> 0003)
PCI: Assigned IRQ 10 for device 00:0b.1
PCI: Sharing IRQ 10 with 00:0b.0
Redundant entry in serial pci_table. Please send the output of
lspci -vv, this message (115d,00d3,8086,2411)
and the manufacturer and name of serial board or modem board
to serial-pci-info@xxxxxxxxxxxxxxxxxxxxxx
register_serial(): autoconfig failed
Floppy drive(s): fd0 is 1.44M
FDC 0 is a National Semiconductor PC87306
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
loop: loaded (max 8 devices)
Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4
ide: Assuming 33MHz system bus speed for PIO modes; override with
idebus=xx
PIIX4: IDE controller at PCI slot 00:07.1
PIIX4: chipset revision 1
PIIX4: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0x1000-0x1007, BIOS settings: hda:DMA, hdb:pio
ide1: BM-DMA at 0x1008-0x100f, BIOS settings: hdc:DMA, hdd:pio
hda: HTS548040M9AT00, ATA DISK drive
blk: queue c0421a00, I/O limit 4095Mb (mask 0xffffffff)
hdc: MATSHITA CR-271, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: attached ide-disk driver.
hda: host protected area => 1
hda: 78140160 sectors (40008 MB) w/7877KiB Cache, CHS=4864/255/63,
UDMA(33)
hdc: attached ide-cdrom driver.
hdc: ATAPI 24X CD-ROM drive, 128kB Cache, DMA
Uniform CD-ROM driver Revision: 3.12
Partition check:
hda: hda1 hda2 hda3 hda4 < hda5 hda6 >
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
mice: PS/2 mouse device common for all mice
md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27
md: Autodetecting RAID arrays.
md: autorun ...
md: ... autorun DONE.
Initializing Cryptographic API
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 4096 buckets, 32Kbytes
TCP: Hash tables configured (established 32768 bind 65536)
Linux IP multicast router 0.06 plus PIM-SM
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
Software Suspend 2.0.0.100: Attempting to set blocksize for 305 to 4096.
Software Suspend 2.0.0.100: Swap space signature found.
Software Suspend 2.0.0.100: Suspending enabled.
Software Suspend 2.0.0.100: Checking for image...
Software Suspend 2.0.0.100: This is normal swap space.
RAMDISK: Compressed image found at block 0
Freeing initrd memory: 111k freed
VFS: Mounted root (ext2 filesystem).
kjournald starting. Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
VFS: Mounted root (ext3 filesystem) readonly.
Trying to move old root to /initrd ... okay
Freeing unused kernel memory: 160k freed
Real Time Clock Driver v1.10f
Adding Swap: 522072k swap-space (priority -1)
EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,3), internal journal
PCI: Enabling device 00:0c.0 (0000 -> 0003)
PCI: Assigned IRQ 5 for device 00:0c.0
ymfpci: YMF744 at 0xfe028000 IRQ 5
ac97_codec: AC97 Audio codec, id: AKM2 (Asahi Kasei AK4543)
kjournald starting. Commit interval 5 seconds
EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,2), internal journal
EXT3-fs: mounted filesystem with ordered data mode.